Engine Oil Level; Hydraulic Oil Level - Prinoth BISON Operating And Maintenance Manual

Table of Contents

Advertisement

Operating and Maintenance Manual
Top up with recommended fluid if level is low. Ensure the coolant temperature is cool before
opening the cap. The cap is located on top of the reservoir and is accessible through a cavity
on top of the rear cowling.
7.2.2

Engine oil level

CAUTION
Burn hazard
Fluids and hot components may cause injury
Switch off the engine and wait for it to cool down.
Never open or remove the oil filler cap while the engine is still hot.
Keep a safe distance.
Check oil level daily when the engine is cool. Allow 30 min between engine stop and oil level check.
1.
To access the oil dipstick, reach through the round opening in the central access panel of the
rear cowling or open the panel.
2.
To unlock the dipstick, push the yellow handle and turn it a quarter of a turn counterclockwise.
3.
Check oil level: The oil level should always remain within the high and low marks on the dip-
stick.
Top up with recommended oil if level is low. Do not overfill. Always use specified oil.
7.2.3

Hydraulic oil level

NOTICE
Retraction or extension of any cylinder on the vehicle will change the quantity of oil in the reser-
voir.
108
(255)
1
Figure 71: Engine oil dipstick
7 - Daily checks
Snow groomer BISON
BISON 908930245 - 30367

Advertisement

Table of Contents
loading

This manual is also suitable for:

Bison x908930245908930367

Table of Contents