Table of Contents
Advertisement
4.
UV Lamp. You can program the Maxwell
be set to turn on after instrument startup or after each run, or it can be set to remain off.
The treatment time can be set in increments of 10 minutes for up to 10 hours. We recommend UV treatment for at least
1 hour. The UV lamp also can be turned on from the Setup menu (see Section 8.D).
Figure 15. UV Settings screen. Select the desired option on the UV screen, then set the time for UV treatment.
5.
Sample Tracking. If you choose "Tracking options-on", you will be able to choose the run report parameters
to track in the Bar code Options screen.
Figure 16. Bar code Options screen. Select the options to be reported.
Important. The options chosen must be entered during the run setup. Options not chosen will be displayed on
!
the Bar code Input screen during run setup (Section 5), but you will not be able to scan bar code data for these
options.
Promega Corporation · 2800 Woods Hollow Road · Madison, WI 53711-5399 USA · Toll Free in USA 800-356-9526 · 608-274-4330 · Fax 608-277-2516
www.promega.com
16 Forensic Instrument to turn on the UV lamp automatically. It can
®
19
TM321 · Revised 4/15
Advertisement
Table of Contents
