Configuring Ipx Routing; Configuration Prerequisite; Configuring An Ipx Static Route - HP A-MSR Series Configuration Manual

The VLAN interface uses its own MAC address as the node address. You need not specify a node

address when enabling IPX.
Step
1. Enter system view.
2. Enable IPX protocol.
3. Enter interface view.
4. Configure an IPX
network number for
the interface.

Configuring IPX routing

With the IPX protocol enabled on an interface, the system automatically enables RIP to maintain and
advertise dynamic routing information. Configure the following routing features based on the actual network
requirements:
Configuring IPX static routes

Configuring IPX route number limit

Configuring IPX RIP static route redistribution

Configuring IPX RIP related parameters


Configuration prerequisite

Before this configuration, you must configure basic IPX functions.

Configuring an IPX static route

Step
1. Enter system view.
2. Configure an IPX static
route.
Command
system-view
ipx enable [ node node ]
interface interface-type
interface-number
ipx network
network-number
Command
system-view
ipx route-static dest-network
{ network.node | interface-
type interface-number }
[ preference value ] [ tick ticks
hop hops ]
3
Remarks
—
Required.
Disabled by default.
—
Required.
By default, no network number is specified for the
interface—IPX is still disabled on the interface even
IPX is enabled in system view.
An interface can only have one network number. If
the IPX network number of an interface is deleted, its
IPX configuration and static routing information is
deleted.
Remarks
—
Required.
The IPX static route with a network number of
0xFFFFFFFE is the default route.
The specified interface-type interface-number
can only be a current PPP interface.