M.2 Ssd; Slots And Bolts For M.2 Ssds - Fujitsu PRIMERGY TX2550 M5 Upgrade And Maintenance Manual

▶ If applicable, remove the riser module, see
page 86.
Replacing the iRMC microSD card
▶ Remove the defective iRMC microSD card, see
microSD card" on page
CAUTION
(not valid for Europe, Middle East, India and Africa)
The iRMC microSD card contains customer information.
▶
After removing the iRMC microSD card, hand the card over to
the customer.
▶
If the customer requests disposal of the defective microSD card,
proceed as follows: Using a pair of side-cutting pliers, cut the
microSD card in half.
▶ Install the new iRMC microSD card, see
on page 487.
Concluding steps
▶ If applicable, install the riser module, see
page 87.
▶
"Reassembling" on page
▶
"Connecting the power cord" on page
▶
"Switching on the server" on page
14.6

M.2 SSD

14.6.1

Slots and bolts for M.2 SSDs

The system board offers two M.2 slots (Key M) with support for 42 mm, 60 mm,
80 mm and 110 mm long M.2 SSDs. With the M.2 SSD an internal SSD is
offered. This SSD can be configured as a boot device or data storage device.
TX2550 M5
489.
68.
82.
83.
Upgrade and Maintenance Manual
System board and components
"Removing the riser module" on
"Removing the iRMC
"Installing the iRMC microSD card"
"Installing the riser module" on
491