Fujitsu PRIMERGY TX2550 M5 Upgrade And Maintenance Manual page 484

System board and components
Figure 314: Removing the TPM spacer
▶ Using a flat nose pliers, press together the hooks on the TPM spacer (1, see
close-up) and remove it from the system board (2).
If the TPM is to be replaced, the TPM spacer may remain on the
system board.
▶ Install the system board, see
Concluding steps
▶ Install the fan bridge, see
▶
"Installing the crossbar" on page
▶ If applicable, install the riser module, see
page 87.
▶
"Installing the PCI air duct" on page
▶
"Installing the system air duct" on page
▶
"Reassembling" on page
▶
"Connecting the power cord" on page
▶
"Switching on the server" on page
▶
"Resuming BitLocker functionality" on page
484
"Installing the new system board" on page
"Handling the fan bridge" on page
91.
89.
68.
68.
82.
83.
Upgrade and Maintenance Manual
"Installing the riser module" on
130.
518.
92.
TX2550 M5