Fujitsu PRIMERGY TX2550 M5 Upgrade And Maintenance Manual page 257

Figure 154: Installing the SAS expander board holder (D)
▶ Connect the following cables to the SAS controller:
1 SAS cable C10 from connector "X1" on SAS expander board to
connector "MLC1"
2 SAS cable C10 from connector "X2" on SAS expander board to
connector "MLC2"
▶ If applicable, connect the OOB cable, see
page 554.
▶ Pull down the SAS expander board holder carefully.
▶ Fasten the SAS expander board holder with the screw (see
For the cable plan, see chapter
TX2550 M5
Hard disk drive (HDD) / solid state disk (SSD)
"Appendix B" on page
Upgrade and Maintenance Manual
"Replacing the OOB cable" on
589.
Figure 144).
257