Fujitsu PRIMERGY TX2550 M5 Upgrade And Maintenance Manual page 184

Hard disk drive (HDD) / solid state disk (SSD)
Preliminary steps
▶
"Locating the defective server" on page
▶
"Shutting down the server" on page
▶
"Disconnecting the power cord" on page
▶
"Getting access to the component" on page
▶ Release all HDD modules and pull them out a few centimeters, see
"Removing a 3.5-inch HDD module" on page
CAUTION
The HDD modules need not to be removed.
▶
If you want to remove them nevertheless, check if all HDD
modules are uniquely identified so that you can reinsert them
into their original bays.
▶ Release all dummy modules and pull them out a few centimeters, see
"Removing a 3.5-inch HDD dummy module" on page
▶
"Removing the system air duct" on page
▶ Remove the fan bridge, see
▶ Disconnect all cables from the defective SAS backplane.
Removing the 3.5-inch HDD bay top cover
The 3.5-inch HDD front cover does not need to be removed in order to
replace a 3.5-inch HDD backplane. In the figures, the front cover has
been removed for illustration purposes only.
184
49.
"Handling the fan bridge" on page
Upgrade and Maintenance Manual
47.
50.
51.
180.
178.
67.
92.
TX2550 M5