Fujitsu PRIMERGY TX2550 M5 Upgrade And Maintenance Manual page 581

Indication of LAN connection supporting Energy Efficient Ethernet (EEE
mode)
To configure the EEE mode, it is necessary that the on board LAN or an add-in
LAN card supports this mode and the connected switch supports this mode as
well.
Indicator
LAN link/
transfer
indicator
LAN speed
indicator
Table 4: LAN indicators if EEE mode is active
Note on the onboard LAN controller
The system board is equipped with a Gigabit Ethernet Controller that
supports transfer rates of 100 Mbit/s and 1 Gbit/s.
The separate management LAN connector is used as a management
interface (iRMC S5) and is prepared for operation with the Remote
Management. Optionally LAN connector 1 can also be used for iRMC
S5 server management.
TX2550 M5
Status
short flashing green 3x,
then off
short flashing yellow 1x,
then 2 seconds off
green off
short flashing green 1x,
then 2 seconds off
yellow off
Upgrade and Maintenance Manual
Description
A LAN connection has been
established (1 Gbit or 100 Mbit)
and EEE mode is active.
Data traffic at a transfer rate of
1 Gbit/s.
Data traffic at a transfer rate of
100 Mbit/s
Appendix A
581