NOTE
Step 3: Connect SCSI
device to your PC
Workstation
NOTE
1 Setting Up and Using Your HP PC Workstation
Connecting an External SCSI Accessory
Connecting an External SCSI Accessory
An external SCSI device can be connected as follows:
1 You should assign an unused SCSI ID to the device. SCSI IDs range
from 0 to 15 for wide 16-bit SCSI devices. Generally, the SCSI ID 0 is
reserved for the first SCSI hard disk drive and SCSI ID 7 is reserved
for the SCSI controller (the default for narrow and wide SCSI
devices).
Depending on your operating system, you may need to set a SCSI ID for
Plug and Play SCSI devices (SCSI devices that support the SCAM
protocol).
2 Make sure the SCSI device is terminated correctly—either internally
or by a terminating resistor (refer to the manual provided with the
SCSI device).
3 Connect the SCSI device to your PC Workstation's external 16-bit
SCSI connector with a shielded SCSI cable.
4 Refer to the manual provided with the SCSI device to learn how to
install any software that may be necessary to use it.
The total length of the external SCSI cables should not exceed 3 meters
(approximately 10 feet).
6
English
Step 2: Make sure
the SCSI device is
terminated
Need help?
Do you have a question about the Kayak XU04 and is the answer not in the manual?