Connecting An External Scsi Accessory - HP Kayak XA User Manual

crystal.bk : cryst-1.fb4 Page 6 Monday, March 23, 1998 4:09 AM
NOTE
1 Setting Up and Using Your PC Workstation

Connecting an External SCSI Accessory

Connecting an External SCSI Accessory
Your PC Workstation is equipped with an UltraWide 16-bit SCSI
connector for external SCSI devices.
When an external SCSI device is connected, the UltraWide 16-bit SCSI
controller automatically switches to non-Ultra mode (maximum
capacity of 20 MBs per second).
An external SCSI device is connected as follows:
1 You should assign an unused SCSI address to the accessory. SCSI
addresses range from 0 to 15 for wide 16-bit SCSI. The SCSI
address 0 is reserved for the first SCSI hard disk drive and SCSI
address 7 is reserved for SCSI controller (the default for narrow and
wide SCSI devices).
Refer to the manual provided with the SCSI accessory for
instructions on selecting a SCSI address.
You don't need to set a SCSI address for Plug and Play SCSI devices
(SCSI devices which support the SCAM protocol).
2 Make sure the SCSI accessory is terminated correctly—either
internally or by a terminating resistor (refer to the manual provided
with the SCSI accessory).
6 English
Make sure the SCSI
accessory is terminated