Connecting An External Scsi Accessory - HP Kayak XU 04xx Manual

NOTE
Step 3: Connect SCSI
device to your PC
Workstation
NOTE
HP Kayak XU PC Workstation — Setting Up and Using Your HP PC Workstation

Connecting an External SCSI Accessory

An external SCSI device can be connected as follows:
1 You should assign an unused SCSI ID to the device. SCSI IDs range
from 0 to 15 for wide 16-bit SCSI devices. Generally, the SCSI ID 0
is reserved for the first SCSI hard disk drive and SCSI ID 7 is
reserved for the SCSI controller (the default for narrow and wide
SCSI devices).
Depending on your operating system, you may need to set a SCSI ID for
Plug and Play SCSI devices (SCSI devices that support the SCAM
protocol).
2 Make sure the SCSI device is terminated correctly—either
internally or by a terminating resistor (refer to the manual provided
with the SCSI device).
3 Connect the SCSI device to your PC Workstation's external 16-bit
SCSI connector with a shielded SCSI cable.
4 Refer to the manual provided with the SCSI device to learn how to
install any software that may be necessary to use it.
The total length of the external SCSI cables should not exceed 3 meters
(approximately 10 feet).
Connecting an External SCSI Accessory
Step 2: Make sure
the SCSI device is
terminated
English
5