Connecting An External Scsi Accessory - HP XL Class 500/550MHz User Manual

NOTE
Setting Up and Using Your HP Visualize Linux Workstation

Connecting an External SCSI Accessory

An external SCSI device can be connected as follows:
1. You should assign an unused SCSI ID to the device. SCSI IDs range
from 0 to 15 for wide 16-bit SCSI devices. Generally, the SCSI ID 0 is
reserved for the first SCSI hard disk drive and SCSI ID 7 is reserved
for the SCSI controller (the default for narrow and wide SCSI
devices).
You don't need to set a SCSI ID for Plug and Play SCSI devices (SCSI
devices that support the SCAM protocol).
2. Make sure the SCSI device is terminated correctly—either internally
or by a terminating resistor (refer to the manual provided with the
SCSI device).
3. Connect the SCSI device to your HP V
external 16-bit SCSI connector with a shielded SCSI cable.
Step 3: Connect
SCSI device to
your workstation
Chapter 1
Connecting an External SCSI Accessory
ISUALIZE
Linux Workstation's
Step 2: Make
sure the SCSI
device is
terminated
7