Put originals on the glass plate
Put originals on the glass plate
Lift the feeder.
1.
[306] Sensor (1)
1: Sensor
#
IMPORTANT
This printer is equipped with an Open/Close sensor on the feeder (see circled area in
the above illustration). When placing originals onto the glass plate, lift the feeder
approximately 300 mm/11 7/8" so that the sensor detaches from the feeder. If the
sensor does not detach from the feeder, the size of the originals may not be detected
correctly.
Place your originals face down.
2.
The surface of the original that you want to copy must be placed face down. Align the
top edge of your original with the back edge of the glass plate (by the arrow in the upper-
left corner).
198
Chapter 7 - Copy jobs
1