Table of Contents
Advertisement
3. Select Position Module.
Built-in
Obtain data from the satellite positioning module built in the device.
Intelligent Display Terminal
Obtain data from display terminal.
4. Select Locating Module.
Note
• The combination mode means the positioning module will be selected automatically. For
example, if GPS/BDS is selected, GPS or BDS will be selected automatically.
• The positioning module varies with models. The actual interface prevails.
5. Optional: Check Enable of Satellite Time Sync to synchronize the device time with satellite
time.
6. Configure speed limit.
1) Select Speed Units.
2) Enter Speed Limit of Alarm.
If vehicle speed exceeds the set value, the device will alarm.
7. Enter Blind Replacement and GPS Upload Interval.
Blind Replacement
In the area without network signal, after the signal restores, the positioning information
from the start time without network signal to the current time will be uploaded. For
example, if you enter 3, after the network signal restores, the data from 3 days ago to now
will be uploaded.
GPS Upload Interval
Mobile Enforcement System User Manual
Figure 10-2 Configure Satellite Positioning
39
Advertisement
Table of Contents
