Table of Contents
Advertisement
Steps
1. Go to Menu → Others → Sensor-In .
2. Check Enable.
Note
If sensor-in is disabled, you can configure it via alarm input. For example, for the recorder with
4-ch alarm inputs, according to the sequence of the parameters on the interface, braking
corresponds to No. 5 alarm input (A<-5), turning left corresponds to No. 6 alarm input (A<-6),
and so on. Refer to "Set Alarm Input" for details.
3. Select Trigger Level and Pop Channel according to actual situation.
The image of selected channel will be displayed in full screen when sensor-in is triggered.
4. Select OK.
6.5 Set Linkage Actions
On the corresponding interface, check Linkage Actions, check the linkage actions as needed, and
save the settings.
Note
Linkage actions vary with event types.
6.5.1 Trigger Recording
To trigger recording when an event occurs, check Trigger Recording.
6.5.2 Trigger Audible Warning
To generate an audible warning when an event occurs, check Audible Warning.
6.5.3 Full Screen Monitoring
To display image from the alarm channel in full screen, check Full Screen Monitoring, and select
Camera to Trigger.
6.5.4 Trigger Alarm Output
To trigger the alarm of alarm output device connected to the recorder, check Trigger Alarm Output
and select the alarm output channel(s).
Mobile Enforcement System User Manual
23
Advertisement
Table of Contents
