3.5 PTZ Operation
Configure PTZ parameters and control PTZ.
3.5.1 PTZ Operation via Manual Controller
Control the connected positioning system lite via manual controller.
• Rotate the joystick clockwise to zoom in.
• Rotate the joystick anticlockwise to zoom out.
• In manual focus mode, press Near+Up to focus on near view. Press Far-Down to focus on far
view.
• Press Setup to enable wiper. Then the wiper will keep running. Press Setup again to disable
wiper.
• Press Day/Night to turn on the supplement light.
3.5.2 PTZ Operation via Touchscreen
Enter live view mode. Tap PTZ, and the PTZ control panel pops up. Operate the PTZ control panel to
control the positioning system.
Note
PTZ operation via touchscreen varies with different models. The actual positioning system prevails.
3.5.3 Set Preset via Manual Controller
Set a preset via manual controller.
Before You Start
Connect positioning system to the recorder, and set the parameters.
Steps
1. Enter live view mode.
2. Rotate the positioning system to a desired view.
3. Adjust its focus and zoom.
4. Hold a numeric button (1 to 9) for 2 seconds until the manual controller makes a single beep
sound.
Note
You can repeat the above steps to add more presets or modify preset. The set presets cannot be
deleted.
Mobile Enforcement System User Manual
12