Table of Contents
Advertisement
Before You Start
Connect a G-sensor to the device.
Steps
1. Go to Configuration → Vehicle → G-Sensor .
2. Select module according to actual situation.
External
The G-sensor is connected to the device via RS-232/RS-485 interface.
Built-in
The G-sensor is a built-in module of the device.
3. Set the limit value for acceleration alarm in X, Y, and Z directions.
Note
X, Y, and Z represent the directions of acceleration and the unit of alarm value is G (G=9.8 m/s
During driving, the device will alarm when acceleration of any direction exceeds the set value.
4. Optional: Set vehicle detection if you want to detect sharp curve, collision, turnover, etc. and
trigger alarm when these behaviors are detected.
1) Check Vehicle Detection.
2) Check the detection(s) according to the actual needs.
3) Enter duration and threshold for the detection(s).
When the vehicle moving exceeds the set threshold, and the detected behavior duration
exceeds the set duration, alarm and record will be triggered.
5. Select the axis indicating the driving direction according to the diagram.
6. Check the linkage actions for acceleration alarm, including Audible Warning and Trigger Alarm
Output.
7. Click Save.
Mobile Enforcement System User Manual
Figure 10-1 Configure G-Sensor
37
2
).
Advertisement
Table of Contents
