MacDon M155 Unloading And Assembly Instructions page 53

III. GAUGES AND CDM DISPLAY
a. Check that engine temperature gauge and fuel
gauge are working.
b. Turn exterior lights ON, and check gauge lights
are ON.
DISPLAY
Engine / Windrower Functions
c. Check CDM display is working by pushing
SELECT on CDM, or SELECT button on GSL.
IV. ELECTRICAL
a. Push the SELECT button on GSL, or SELECT
switch on CDM to display VOLTS. The display
indicates the condition of the battery and
alternator. Refer to table below.
IGNITION ENGINE
Running
ON
Shut Down
Display flashes voltage reading with single
loud tone. Repeats every 30 minutes until
condition is fixed.
V. ENGINE SPEED
WINDROWER IDLE
M155
1075 - 1150
M205
a. Check engine idle and maximum rpm on CDM.
Form 169540
PRE-DELIVERY CHECKS
INDICATED
READING
CONDITION
13.8 - 15.0 Normal.
> 16.0
Regulator Out of
Adjustment.
See Note.
Alternator Not
< 12.5
Working, OR
Regulator Out of
See Note.
Adjustment.
12.0 Battery Normal.
NOTE
MAX RPM (No Load)
2320 - 2350
2250 - 2340
VI. OPERATOR'S PRESENCE SYSTEM
CHECKS
a. With the windrower engine running, place the GSL
in NEUTRAL, and turn steering wheel until it locks.
CAUTION
Check to be sure all bystanders have cleared
the area.
b. With everyone clear of the machine, engage
HEADER DRIVE switch.
1. After header drives are running, stand up out
of the seat. In approximately 5 seconds, the
header should shut off.
If not, the Operator Presence System requires
adjustment. See Technical Service Manual.
To re-start the header, move the header
engage switch to OFF position, and back to
the ON position again.
c. With the engine running, position the GSL in
NEUTRAL and in N-DETENT;
1. Swivel the Operator's station, but do not lock
into position.
2. Move GSL out of N-DETENT. The engine
should shut down, and the lower display will
flash "LOCK SEAT BASE ---> CENTER
STEERING WHEEL ---> NOT IN NEUTRAL".
3. Swivel and lock the Operator's station, and
the display should return to normal.
4. If the engine does not shut down, the seat
position switches require adjustment. Refer to
Technical Service Manual.
d. With windrower moving at less than 5 mph
(8 km/h):
1. Stand up out of the seat.
2. The CDM will flash "NO OPERATOR" on the
upper line, and "ENGINE SHUTDOWN
5...4...3...2...1...0"
accompanied by a steady tone. At "0", the
engine shuts down.
3. If the engine does not shut down, the
Operator
adjustment. See Technical Service Manual.
e. With windrower moving at more than 5 mph
(8 km/h):
1. Stand up out of the seat.
2. The CDM beeps once, and displays "NO
OPERATOR" on the lower line. If not, the
Operator
adjustment. See Technical Service Manual.
53
NOTE
on the lower
Presence System
Presence System
Revision B
line
requires
requires