MacDon M155 Unloading And Assembly Instructions page 30

h. Install pin (N) through each boot and foot, and
secure with hairpin.
IMPORTANT
Ensure pin (N) is fully inserted, and hairpin
is installed behind bracket.
i. Remove lynch pin from pin (O) in stand (P).
j. Hold stand (P), and remove pin (O).
k. Re-position stand to "storage position" by inverting
stand, and re-locating on bracket as shown
l. Re-insert pin (O), and secure with lynch pin.
Form 169540
UNLOADING AND ASSEMBLY
N
P
O
m. Remove pin (Q) from "storage position" in linkage,
and insert in hole (R) to engage float springs.
Secure with lynch pin.
n. Disengage lift cylinder stop by turning lever (L)
downward to raise stop until lever locks into
"vertical" position.
o. Repeat for opposite cylinder
CAUTION
Check to be sure all bystanders have cleared
the area.
HEADER UP
HEADER
TILT DOWN
p. Start engine, and activate HEADER DOWN switch
on GSL to lower header fully.
30
Q
R
L
s
top.
REEL UP
HEADER TILT UP
(continued next page)
Revision B