MacDon M155 Unloading And Assembly Instructions page 27

CAUTION
Check to be sure all bystanders have cleared
the area.
REEL DOWN
HEADER UP
HEADER
TILT DOWN
HEADER DOWN
b. Start engine, and activate HEADER DOWN button
on the GSL to fully retract header lift cylinders.
IMPORTANT
If the center link is too low, it may contact
the header as the windrower approaches
the header for hook-up.
E
c. If necessary, adjust position of the hydraulic
center link (E) so that the hook (F) is above the
attachment pin on the header by one of the
following methods:
1. If the optional center link self-alignment kit is
installed, activate the REEL UP switch on the
GSL to raise the center link (E).
Form 169540
UNLOADING AND ASSEMBLY
REEL UP
HEADER TILT UP
F
27
2. Without the self-alignment kit, re-locate the pin
(G) at the frame linkage as required to raise
the center link (E).
H
d. Slowly drive windrower forward so that feet (H) on
windrower enter boots (B) on the header.
Continue to drive slowly forward until feet engage
the boots, and header nudges forward.
G
E
B
(continued next page)
Revision B