MacDon M155 Unloading And Assembly Instructions page 25

S
F
h. Install pin (F) through header leg, (engaging
U-bracket in lift linkage) on both sides, and secure
with hairpin.
i. Raise header stand (R) to "storage position" by
pulling pin (S), and lifting stand into "uppermost"
position. Release pin (S).
j. Remove pin from "storage position" (T) in linkage,
and insert in hole (U) to engage float springs.
Secure with hairpin.
k. Disengage lift cylinder stop by turning lever (P)
downward to release and lower stop until lever
locks into "vertical" position.
l. Repeat for opposite lift cylinder stop.
CAUTION
Check to be sure all bystanders have cleared
the area.
m. Start engine, and activate HEADER DOWN switch
on GSL to lower header fully. Stop engine, and
remove key.
Form 169540
UNLOADING AND ASSEMBLY
R
T
U
P
WARNING
Stop windrower engine, and remove key
before making adjustments to machine. A
child or even a pet could engage the drive.
W
n. Connect header drive hoses (V) and electrical
harness (W) to header.
Header Operator's Manual.
o. Connect reel hydraulics (X) at RH side of
windrower. Refer to the Draper Header Operator's
Manual.
25
Refer to the Draper
X
V
Revision B