MacDon M155 Unloading And Assembly Instructions page 28

e. Connect center-link:
HYDRAULIC LINK WITH OPTIONAL
SELF-ALIGNMENT KIT
REEL DOWN
HEADER UP
HEADER
TILT DOWN
HEADER DOWN
1. Adjust position of the center-link cylinder (E)
with the REEL UP and REEL DOWN
switches, and HEADER TILT switches on the
GSL to position the hook above the header
attachment pin.
IMPORTANT
Hook release (J) must be down to
enable self-locking mechanism. If the
release is open ("up"), manually push it
down after hook engages header pin.
Form 169540
UNLOADING AND ASSEMBLY
REEL UP
HEADER TILT UP
J
E
2. Lower the center-link onto the header with
REEL DOWN switch until it locks into position
(hook release (J) is "down").
3. Check that center-link is locked onto header
by pressing the REEL UP switch on the GSL.
4. Proceed to step f. on next page.
HYDRAULIC LINK WITHOUT
SELF-ALIGNMENT KIT (M205 STANDARD,
M155 OPTIONAL)
1. Activate HEADER TILT cylinder switches on
GSL to extend or retract center-link cylinder
(E) so that the hook lines-up with the header
attachment pin.
2. Stop engine, and remove key from ignition.
3. Push down on rod end of link cylinder (E) until
hook engages pin on header, and is locked.
Hook release (J) must be down to enable
self-locking mechanism. If the release is
open ("up"), manually push it down after
hook engages header pin.
4. Check that the center-link is locked onto
header by pulling upward on rod end of
cylinder.
5. Proceed to step f. on next page.
28
J
IMPORTANT
(continued next page)
Revision B