MacDon M155 Unloading And Assembly Instructions page 21

II. ATTACH HEADER BOOTS
IMPORTANT
To prevent damage to the lift system when
lowering header lift linkages without a
header or weight
windrower, ensure that float engagement
pin is installed in storage location (A), and
not installed at hole location (B).
D
If not installed, attach draper header boots
(supplied with header) to windrower lift linkage as
follows:
a. Remove pin (C) from boot (D).
Form 169540
UNLOADING AND ASSEMBLY
A
B
box attached
C
b. Locate boot (D) on lift linkage (E), and re-install
pin (C). Pin may be installed from either side of
boot.
to
c. Secure pin (C) with hairpin.
d. Repeat for opposite side.
21
E
D
C
Revision B