3
Safety instructions
Please follow these safety directions and instructions regarding installation, commissioning
and operation of the SP190-H/DIL-EX2 T*:
Read this manual before commissioning and operating the product. Please make sure to follow
•
all safety instructions.
Installation and commissioning of electrical devices must be carried out only by qualified skilled
•
personnel in compliance with the current regulations.
The installation and commissioning of the device must conform to the requirements of VDE 0100
•
(IEC 364) 'Regulations on the Installation of Power Circuits with Nominal Voltages below 1000V'
and must be in compliance with all relevant regulations and standards.
•
Furthermore, the supplements for the installation of electrical systems, as in EN 60079-14, must
be complied with.
When used in hazardous areas, the relevant national and international standards and regulations
•
must be observed.
•
Before connecting the device, please make sure to compare the supply voltage with the specified
voltage on the product label.
Protection against damages caused by high voltages:
•
Disconnect the power supply before opening the device for access. Make sure that all extern
power supplies are disconnected.
Operate the device only in the permitted temperature and pressure ranges. For details please
•
refer to the technical data sheet or manual.
Install the device only in protected areas, sheltered from rain and moisture. The product should
•
not be exposure to the elements.
•
Installation, maintenance, inspections and any repairs of the devices must be carried out only by
qualified skilled personnel in compliance with the current regulations.
www.mc-techgroup.com
SP190-H/DIL-EX2 T* | 1.01.00
5