Safety Instructions; Warranty - M&C PMA Series Instruction Manual

3

SAFETY INSTRUCTIONS

Please take care of the following basic safety procedures when mounting, starting up or operating
this equipment:
Read this operating manual before starting up and use of the equipment. The information and warnings
given in this operating manual must be heeded.
Any work on electrical equipment is only to be carried out by trained specialists as per the regulations cur-
rently in force.
Attention must be paid to the requirements of VDE 0100 (IEC 364) when setting high-power electrical units
with nominal voltages of up to 1000 V, together with the associated standards and stipulations.
Check the details on the type plate to ensure that the equipment is connected to the correct mains voltage.
Protection against touching dangerously high electrical voltages:
Before opening the equipment, it must be switched off and hold no voltages. This also applies to any external
control circuits that are connected.
The device is only to be used within the permitted range of temperatures and pressures.
Check that the location is weather-protected. It should not be subject to either direct rain or moisture.
The device must not be used in hazardous areas.
Installation, maintenance, monitoring and any repairs may only be done by authorized personnel with re-
spect to the relevant stipulations.
4

WARRANTY

If the equipment fails, please contact M&C directly or else go via your appointed M&C dealer.
We offer a one year warranty as of the day of delivery as per our normal terms and conditions of sale and
assuming technically correct operation of the device. Consumables are hereby excluded. The terms of the
warranty cover repair at the factory at no cost or the replacement at no cost of the equipment free ex user
location. Reshipments must be sent in a sufficient and proper protective packaging.
6 PMA30 | 1.01.03 www.mc-techgroup.com