Enclosure Diagnostic Steps - HP Blade bc1000 Setup And Installation Manual

Enclosure Diagnostic Steps

Table D-1: Enclosure Diagnostic Steps
Question
Question 1: Is the power LED on both power
supplies solid green?
Question 2: Is the fault LED on both power
supplies off?
Question 3: Is the enclosure power LED on the
rear panel green?
Question 4: Is the enclosure health LED on the
front of the enclosure on?
Question 5: Is the local management console
displaying information when connected to the
enclosure?
Question 6: Is the Integrated Administrator health
LED green?
Question 7: Is the fan health LED green?
Ä
Setup and Installation Guide
If your enclosure does not function properly, use Table D-1 to
determine appropriate actions based on the symptoms observed. Start
with question 1 and work your way through the table in order to
narrow down possible causes and identify actions or solutions.
According to the answers you give to the questions in Table D-1, you
are directed to the appropriate table in the section that immediately
follows. That table outlines possible reasons for the problem, options
available to assist in diagnosis, and possible solutions.
CAUTION: Pressing the enclosure power button while the enclosure is
running shuts down the enclosure and all Blade PCs.
www.hp.com
Answer
If yes, continue to Question 2 of this table.
If no, see Table D-2.
If yes, continue to Question 3 of this table.
If no, see Table D-3.
If yes, continue to Question 4 of this table.
If no, see Table D-4.
If yes, continue to Question 5 of this table.
If no, see Table D-5.
If yes, use the displayed information for further
diagnosis.
If no, see table D-6, or continue to Question 6.
If yes, continue to Question 7 of this table.
If no, see Table D-7.
If yes, and you are still unable to access the local
console, contact HP or your authorized service
provider for parts and service.
If no, see Table D-8.
Troubleshooting
D-5