HP Blade bc1000 Setup And Installation Manual page 93

POST Error Messages (Continued)
Code/Message
1720-SMART Hard
Drive detects imminent
failure
1780-Disk 0 Failure
1782-Disk Controller
Error
1790-Disk 0 Error
1800-Temperature
Alert
Setup and Installation Guide
Health LED Possible Cause
Amber Hard drive is about to
fail.
Amber Hard drive has failed.
Red Hard drive circuitry error
has occurred.
Amber Hard drive has failed.
Amber Internal temperature
exceeds specification.
www.hp.com
POST Error Messages
Recommended Action
1. Run Drive Protection
System if applicable.
2. Apply firmware patch
(www.hp.com/support).
3. Back up contents and
replace the hard drive.
1. Run IDE Self-Test from
Computer Setup (F10).
2. Replace the hard drive.
1. Run IDE Self-Test from
Computer Setup (F10).
2. Replace the hard drive.
3. Replace the system
board.
1. Run IDE Self-Test from
Computer Setup (F10).
2. Replace the hard drive.
3. Replace the system
board.
1. Ensure that the system
fans are functioning
properly and that the
enclosure has adequate
ventilation.
2. Check the processor heat
sink.
3. Replace the system
board.
C-3