HP Blade bc1000 Setup And Installation Manual page 39

Å
Å
Ä
Setup and Installation Guide
4. Place the hexagonal washer at the back of the hole in the
enclosure 1.
5. Insert the screw through the hole in the enclosure.
6. Press the head of the screw inward so that the spring is
completely compressed 2.
7. Screw the hexagonal washer onto the shaft of the screw until it
passes all the threads and is secure within the thumbscrew
housing 3.
Replacing a thumbscrew, spring, and hexagonal washer
8. Repeat steps 1 through 7 for the other thumbscrew.
WARNING: Remove the two hot-plug power supplies before installing
the enclosure into the rack to reduce weight.
WARNING: At least two people must lift the enclosure into the rack
together. If the enclosure is loaded into the rack above chest level, a third
person must assist with aligning the enclosure with the rails while the
other two people support the weight of the enclosure.
CAUTION: Do not remove the enclosure from the rack by the
thumbscrews. Use the handles located above the thumbscrews.
www.hp.com
Installing and Cabling the HP CCI Solution
4-11