HP Blade bc1000 Setup And Installation Manual page 103

Ä
Table D-4: Is the Enclosure Power LED on the Rear Panel Green?
Answer
No, it is off.
No, it is amber.
Yes, it is green.
Setup and Installation Guide
CAUTION: Pressing the enclosure power button while the enclosure is
running shuts down the enclosure and all Blade PCs.
Possible Reasons
The cable is not properly
connected between the fan
backplane and the power
backplane.
The interconnect tray is not fully
inserted.
The Integrated Administrator
module is not properly seated.
The fan backplane assembly has
failed.
The connector on the power
backplane is damaged.
The power backplane has failed.
The enclosure is in standby
mode.
If the enclosure power LED is green, return to Table D-1.
www.hp.com
Possible Solutions
Be sure that the connectors on the fan
cable are properly seated and not
damaged.
Remove and reseat the interconnect
tray.
Contact HP or your authorized service
provider for parts and service.
Push the enclosure power button on
the fan cage at the rear of the
enclosure.
Caution: Pressing the enclosure
power button while the enclosure is
running shuts down the enclosure and
all Blade PCs.
Troubleshooting
D-9