Cabling The Hp Cci Solution - HP Blade bc1000 Setup And Installation Manual

Installing and Cabling the HP CCI Solution

Cabling the HP CCI Solution

4-12
To load the enclosure into the rack:
1. Install the interconnect tray. See the
Tray" section in this chapter.
2. Stand at the front of the rack.
3. Align the bottom of the enclosure with the top of the rack rails.
4. Slide the enclosure fully into the rack 1.
5. Tighten the thumbscrews to secure the enclosure in the rack 2.
Installing the enclosure into the rack
An HP CCI solution requires no internal cabling. External cabling is
achieved through the interconnect switch installed in your solution.
The procedure for cabling an enclosure consists of the following
steps:
Identifying the interconnect switch connectors
Cabling the blade enclosure
www.hp.com
"Installing the Interconnect
Setup and Installation Guide