Installing The Terminal - Ingenico iCT200 Series User Manual

Installing the Terminal

4.
Installing the Terminal via PSTN
Before switching the power on at the mains socket,
ensure the mains supply is connected to the circular
power port on the terminal's connector box.
Ensure the supplied telephone cable is connected to the
telephone IN port on the terminal's connector box, and
into your telephone socket.
Position the terminal in a clear area where the display can be read and the keypad and card
reader are easily accessible. Ensure that you have a Merchant Number to hand. This can be
found in your Welcome Letter.
Now switch the power on at the mains supply.
Dual Comms Mode
You should use the
required option and then press the GREEN button. For
PSTN installation select Telephone (PPP).
1. Ensure the telephone line is connected to the terminal and to the wall socket and then press the
GREEN button.
If your terminal is connected via a direct line, select NO by pressing the YELLOW button.
2. If it is connected to a Switchboard/PABX, select YES by pressing the GREEN button.
3. If you selected the Switchboard/PABX option, key in
the number used to get an outside line (often 9) and then
press the GREEN button.
4. If your telephone line has Call Waiting or 1571 press
the GREEN button.
PLEASE NOTE: If you have Call Waiting and select NO when prompted, the terminal will be
unable to dial for authorisation when a call message is waiting.
5. Key in your Merchant Number and press the GREEN
button.The terminal will start to dial the Host computer
and a number of communication messages will be
displayed.
6. The terminal may then contact any card acquirers it is
configured to accept. Further communication messages
will be displayed.
Page 6
keys to highlight the
Terminal Installation
Plug in Phone Line
and then press ENTER
Dial Prefix Required ?
Enter=YES Clear=NO
Connection Method
Telephone (PPP)
Local Network
Key in the Number used to get
an Outside Line
and then press ENTER
Does the Tel. Line have
Call Waiting or 1571 ?
Enter=YES
Terminal Installation
Key in Merchant No.
and then press ENTER
Terminal Installation
Connecting to
<Acquirer Name>
Please Wait...
Clear=NO