Ingenico iCT200 Series User Manual page 8

Hide thumbs Also See for iCT200 Series:
Table of Contents

Advertisement

7. An installation report will then be printed displaying the
card types that your terminal will accept.
8. Finally, the terminal will dial the Host computer to
report the successful installation.
Installation is now complete and the terminal will display
the READY prompt. Your terminal is now ready for use.
Check the date and time on your terminal. If this needs to
be corrected refer to Section 35 of this guide for further
details.
Installing the Terminal via Ethernet (IP)
Before switching the power on at the mains socket, ensure the mains supply is connected to the
circular power port on the terminal's connector box.
Ensure that the Ethernet cable is connected to the ETH port on the terminal's connector box, and
to your router or network point.
Position the terminal in a clear area where the display can be read and the keypad and card
reader are easily accessible.
Ensure that you have your Merchant Number to hand. This can be found in your Welcome Letter.
Now switch the power on at the mains supply.
Dual Comms Mode
You should use the
required option and then press the GREEN button to
select.
For installation over IP select Local Network.
1. Ensure the Ethernet cable is connected to the terminal
and press the GREEN button.
2. Key in your Merchant Number and press the GREEN
button.
The terminal will attempt to connect to the Host
computer and a number of communication messages will
be displayed.
The terminal may then contact any acquirers it is
configured to accept. Further communications messages
will be displayed.
3. An installation report will then be printed displaying the
card types that your terminal will accept.
Finally, the terminal will contact the Host computer to
report the successful installation.
keys to highlight the
READY
Merchant Number
12345678
Connection Method
Telephone (PPP)
Local Network
Terminal Installation
Plug in Network
Cable
and then press ENTER
Terminal Installation
Key In Merchant No.
and then press ENTER
Terminal Installation
Connecting to
<Acquirer Name>
Please Wait...
READY
Merchant Number
12345678
Page 7

Advertisement

Table of Contents
loading

Table of Contents