Ingenico iCT200 Series User Manual page 4

Maintenance
Cleaning the Case
• DO NOT allow any water to enter inside the case. Remove any dust from the case using a
damp cloth. To clean off accumulated dirt and grime, use a damp cloth that has previously
been dipped in mild soap and water. Wring out thoroughly to remove excess water before
use.
• DO NOT use solvents, cleaning fluids or abrasives. These materials could damage the
plastic housing and any exposed contacts.
External Power Supply
• This apparatus is intended for use when supplied with power from a low voltage external
power supply.
• Only an Ingenico approved power supply (CE Marked) specified for use with this Terminal
may be used.
• Since this product does not have a disconnect device (ON/OFF switch), the Terminal and
Power Supply must be installed near a suitable power socket which is easily accessible.
• In the event of a hazard or malfunction, the Power Supply Unit should be switched off at the
socket before being unplugged from the mains.
• The power supply output lead should only be plugged into the product power input socket.
• The power supply will provide adequate power for the Terminal. The user should ensure
that all other auxiliary apparatus, drawing power from the host, does not overload the power
supply.
• Operate only from a power source as specified on the Power Supply Unit.
A damaged mains cord (if not a replaceable type) or low voltage secondary input lead cannot
be replaced by the user, the unit must be returned to the authorised service agent for essential
repairs and/or replacement.
Connections
Interconnection to other equipment via the externally accessible ports on the Terminal must only
be made as follows:
Power Supply Input: Operates at Safety Extra Low Voltage (SELV). Connect only to an Ingenico
approved Power Supply (CE Marked) specified for use with the Terminal.
Port(s), 6 way: The RS232 type port(s) operate at SELV and must only be connected to a module
of the same type ie. SELV.
Public Switched Telephone Network (PSTN) Line, 6 Way: MUST only be connected to a PSTN
socket e.g. Telephone wall socket, PBX etc. Under no circumstances must the PSTN cable be
inserted into the RS232 ports. Take due care when attaching cables.
Page 3