Set F3 Label; Set F4 Label - Datalogic PowerScan 9500 Series Product Reference Manual

Enter/Exit Programming Mode

Set F3 Label

This item allows the user to change the default mnemonic label associated
to each individual function key. This is done by programming a short acro-
nym 4-character string to be shown in the bottom of the display. The pur-
pose of the label is to serve as an indication of the programmed function of
the Function Key below it.
$CPWSD
Set F3 label

Set F4 Label

This item allows the user to change the default mnemonic label associated
to each individual function key. This is done by programming a short acro-
nym 4-character string to be shown in the bottom of the display. The pur-
pose of the label is to serve as an indication of the programmed function of
the Function Key below it.
$CPWSE
Set F4 label
268
To configure this feature, scan the ENTER/EXIT PRO-
GRAMMING MODE bar code above, then the bar code at
left followed by 8 digits from the
pad. The digits must be the hexadecimal ASCII represen-
tation of the desired characters.
End by scanning the ENTER/EXIT bar code again.
To configure this feature, scan the ENTER/EXIT PRO-
GRAMMING MODE bar code above, then the bar code at
left followed by 8 digits from the
pad. The digits must be the hexadecimal ASCII represen-
tation of the desired characters.
End by scanning the ENTER/EXIT bar code again.
PowerScan™ PD9530/PBT9500/PM9500
Appendix D, Key-
Appendix D, Key-