Rs-485 Slave Minimum Address; Rs-485 Slave Maximum Address - Datalogic PowerScan 9500 Series Product Reference Manual

Enter/Exit Programming Mode

RS-485 Slave Minimum Address

Specifies the minimum address that can be set for a Cradle in an RS-485
network.
The maximum number of cradles in a single network is 16 (including the Master if
present). All cradles in the system must have different addresses.
$CR4JB
Slave Minimum Address
Make a mistake? Scan the CANCEL bar code to abort and
not save the entry string. You can then start again at the
beginning.

RS-485 Slave Maximum Address

Specifies the maximum address that can be set for a Cradle in an RS-485
network.
The maximum number of cradles in a single network is 16 (including the Master if
present). All cradles in the system must have different addresses.
$CR4JC
Slave Maximum Address
Make a mistake? Scan the CANCEL bar code to abort and
not save the entry string. You can then start again at the
beginning.
244
To configure this feature, scan the ENTER/EXIT PRO-
GRAMMING MODE bar code above, then the bar code at
left followed by four digits from the Alphanumeric char-
acters in
Appendix D, Keypad
desired character(s). End by scanning the ENTER/EXIT
bar code again.
~
CANCEL
To configure this feature, scan the ENTER/EXIT PRO-
GRAMMING MODE bar code above, then the bar code at
left followed by four digits from the Alphanumeric char-
acters in Appendix D, Keypad
desired character(s). End by scanning the ENTER/EXIT
bar code again.
~
CANCEL
PowerScan™ PD9530/PBT9500/PM9500
representing your
representing your