Permanent Mounting - Datalogic PowerScan 9500 Series Product Reference Manual

Setup
To change the Bracket:
1. Remove the screw holding the Bracket in place. Retain the screw for re-
2. Carefully lift off the Bracket.
3. Install the other bracket by first slipping the end tab into place on the
4. Replace the screw to secure the Bracket to the Base Station.
Figure 2. Changing the Bracket

Permanent Mounting

For either desktop or wall mounting, the cradle can be fastened directly to a
flat surface using screws (not included).
Figure 3. Base Station Bottom
10
use.
base station, then easing the tabs (shown in
place on the sides.
3
When mounting on drywall, the base should be screwed to a wall stud or
supporting beam for additional support.
Rubber Feet
Protective Adhesive
1
Mounting
Strips
Holes
PowerScan™ PD9530/PBT9500/PM9500
Figure 1 on page 9) into
2
Rubber Feet