Pm9500-Only Features; Star Radio Protocol Timeout - Datalogic PowerScan 9500 Series Product Reference Manual

Enter/Exit Programming Mode
The features in this section are valid only for the PowerScan PM9500 Star
model:
•
•

STAR Radio Protocol Timeout

This parameter sets the valid wait time before transmission between the
handheld reader and Base Station is considered failed.
When setting this parameter, take into consideration the radio traffic (num-
ber of readers in the same area). The selectable range for this feature is
from 02 to 25 seconds. See
tion and examples for setting this feature.
Set Radio Protocol Timeout
Make a mistake? Scan the CANCEL barcode to abort
and not save the entry string. You can then start again
at the beginning.
DEFAULT
236

PM9500-ONLY FEATURES

STAR Radio Protocol Timeout on page 236
STAR Radio Transmit Mode on page 237
02 = 2 Seconds Radio Protocol Timeout
page 305 in "References" for detailed informa-
To configure this feature, scan the ENTER/EXIT PRO-
GRAMMING MODE bar code above, then the bar code
at left followed by two digits from the Alphanumeric
characters in
Appendix D, Keypad
your desired character(s). End by scanning the
ENTER/EXIT bar code again.
~
PowerScan™ PD9530/PBT9500/PM9500
representing
CANCEL