Datalogic PowerScan 9500 Series Product Reference Manual page 32

Enter/Exit Programming Mode
•
To program features:
1. Scan the ENTER/EXIT PROGRAMMING bar code, available at the top of
2. Scan the bar code to set the desired programming feature. You may
3. If additional input parameters are needed, go to
4. Complete the programming sequence by scanning the ENTER/EXIT
For more detailed descriptions, programming information and examples for
setting selected configuration items, see
22
"2D Symbologies" on page 173 provides configuration of a personal-
ized mix of 2D codes, code families and their options.
You must first enable your reader to read bar codes in order to use
this section. If you have not done this, go to
and complete the appropriate procedure.
page 7
each programming page, when applicable.
need to cover unused bar codes on the page, and possibly the facing
page, to ensure that the reader reads only the bar code you intend to
scan.
and scan the appropriate characters from the keypad.
Additional information about many features can be found in the "Ref-
erences" chapter.
If you make a mistake before the last character, scan the CANCEL bar
code to abort and not save the entry string. You can then start again
at the beginning.
PROGRAMMING bar code to exit Programming Mode.
Setup, starting on
Appendix D,
References, starting on page
PowerScan™ PD9530/PBT9500/PM9500
Keypad,
271.