Micro Qr Code Length Control; Micro Qr Code Set Length 1 - Datalogic PowerScan 9500 Series Product Reference Manual

Enter/Exit Programming Mode

Micro QR Code Length Control

This feature specifies either variable length decoding or fixed length decod-
ing for this symbology.
Variable Length:
length may be set.
Fixed Length:
DEFAULT
$CMQLC01(CR)
Micro QR Code Length Control = Fixed Length

Micro QR Code Set Length 1

Specifies one of the bar code lengths for Micro QR Code Length Control.
Length 1 is the minimum label length if in
fixed length if in Fixed Length Mode. Characters can be set from 0001 to
0035 characters in increments of 0001 (pad with zeroes).
See page 283
$CMQL1
Select Micro QR Code Length 1 Setting
Make a mistake? Scan the CANCEL bar code to abort
and not save the entry string. You can then start
again at the beginning.
198
For variable length decoding, a minimum and maximum
For fixed length decoding, two different lengths may be set.
for detailed instructions on setting this feature.
0001 = Length 1 is 1 Character
DEFAULT
$CMQLC00(CR)
Micro QR Code Length Control = Variable Length
Variable Length
To configure this feature, scan the ENTER/EXIT
PROGRAMMING MODE bar code above, then the bar
code at left followed by the digits from the Alphanu-
meric characters in
Appendix D, Keypad
senting your desired character(s). End by scanning
the ENTER/EXIT bar code again.
~
CANCEL
PowerScan™ PD9530/PBT9500/PM9500
2D Global Features
Mode, or the first
repre-