Mounting For Portable Use - Datalogic PowerScan 9500 Series Product Reference Manual

Mounting for Portable Use

If portability of the cradle is required, the metal plate must be used. There
are two ways this can be done: (1) by first mounting the metal plate on a flat
surface so the cradle can be slid off and on, or (2) mounting the metal plate
onto the back of the base station and then screwing both to the desired sur-
face.
Mounting the Metal Plate
1. Affix the metal plate onto the desired mounting surface using the two
2. Remove the adhesive strips protecting the mounting tabs on the cradle,
3. Slide the tabs on the back of the cradle onto the metal plate as shown
4. After aligning the tabs, push up to lock into place.
Figure 4. Mounting Plate on Wall
Product Reference Guide
For additional security on wall mounting, it is strongly recommended
that the cradle be secured into place using two auxiliary screws through
the mounting holes on the side.
center screw holes (see Figure 4 on page 11).
shown in Figure 3.
in Figure 4.
Mounting the BC9xx0 Cradle
11