Permanent Mounting; Mounting For Portable Use; Mounting The Metal Plate - Datalogic BC9 0-BT Series Quick Reference Manual

Permanent Mounting

For either desktop or wall mounting, the cradle can be fastened directly to a
flat surface using screws (not included).
When mounting on drywall, the base should be screwed to a wall stud
or supporting beam for additional support.
NOTE
Figure 3. Base Station Bottom
A
A Rubber Feet

Mounting for Portable Use

If portability of the cradle is required, the metal plate must be used. There are
two ways this can be done: (1) by first mounting the metal plate on a flat sur-
face so the cradle can be slid off and on, or (2) mounting the metal plate onto
the back of the base station and then screwing both to the desired surface.
For additional security on wall mounting, it is strongly recommended
that the cradle be secured into place using two auxiliary screws
through the mounting holes on the side.
NOTE

Mounting the Metal Plate

1. Affix the metal plate onto the desired mounting surface using the
two center screw holes (see
2. Remove the adhesive strips protecting the mounting tabs on the
cradle, shown in
3. Slide the tabs on the back of the cradle onto the metal plate as
shown in
4. After aligning the tabs, push up to lock into place.
Quick Reference Guide
B
Protective adhesive
B
strips
Figure 3.
Figure 4.
C
C Mounting Holes
Figure 4 on page
Mounting the BC9xx0-BT Cradle
A
6).
5