Operation Timing; Control Input (Hold, Reset, Zero) - KYOWA WGA-670B-0 Instruction Manual

5. OPERATION TIMING

5-1 CONTROL INPUT (HOLD, RESET, ZERO)

Operating Status Operating Status
HOLD HOLD
RESET RESET
ZERO ZERO
T1: 4ms(Max) ...................... A period of time required for starting the HOLD operation starting from the
T2: 4ms(Max) ...................... When it is in peak hold mode and arbitrary point hold mode, a period of
T3: 4ms(Max) ...................... When it is in block specified hold mode and time specified hold mode, a
T4: 4ms(Max) ...................... A period of time required for starting digital ZERO operation starting from
T5: 4ms(Max) ...................... A period of time required for canceling the digital ZERO operation starting
T6: 5ms(Min) ...................... Time required for the [HOLD] signal.
T7: 5ms(Min) ...................... Time required for the [RESET] signal.
T8: 5ms(Min) ...................... Time required for the [ZERO] signal.
Starts Starts Starts
the hold operation the hold operation the hold operation
T1 T1
OFF OFF
ON ON
T6 T6
OFF OFF
ON ON
OFF OFF
ON ON
[HOLD] signal ON.
time required for canceling the HOLD operation starting from the [HOLD]
signal OFF.
period of time required for canceling the HOLD operation starting from the
[RESET] signal ON.
the [ZERO] signal ON.
from the [ZERO] signal OFF.
Starts Starts
digital ZERO digital ZERO
Cancels Cancels
operation operation
the hold operation the hold operation
T2 T2
T3 T3
T7 T7
T4 T4
T8 T8
28
Cancels Cancels
digital ZERO digital ZERO
operation operation
T5 T5