Table of Contents
Advertisement
4-2 FUNCTION
4-2-1 Various Functions in Function Selecting Mode
• Function selecting mode has the following 14 functions.
F-01: Original value
F-02: Actual Load Calibration
F-03: Sensitivity Registering Calibration
F-04: Hold Mode
F-05: Self Check
F-06: D/A Output Scale
F-07: Smoothing
• For details of each function, see the following Table 4-2-1.
Function
Function Name
Selecting Mode
F-01
Original Value
F-02
Actual Load
Calibration
Table 4-2-1 Various Functions in Function Selecting Mode
Key Operation & WGA-670B
Movement in Function Setting Mode
'. . . . . ' is indicated.
Press the SET key at this time and the
current input value is indicated in the unit
of mV/V.
Conduct digital ZERO function with no
load applied to the transducer.
Then, apply load to the transducer.
Set a numerical value to be indicated at
this time and press the SET key.
Next, set a decimal point position and
press the SET key.
•Key code enable setting
'00000' is indicated.
Here, set the indication to read '00628' or
'11111' and press the SET key. Then,
calibration value is updated.
The key code is enabled. Therefore, when
the calibration value is updated the next
time, the above operation is required. To
disable the key code, use the function
'F-12.'
•Key code disable setting
'00000' is indicated.
Press the SET key as it is.
Then, the calibration value is updated.
The key code is disabled and the
calibration value is updated even if no
key code entered.
F-08: Additional Value
F-09: Automatic ZERO Compensation
F-10: Hysteresis
F-11: BCD Output Logic
F-12: Initialize
F-13: BV Select
F-14: TEDS ON/OFF
12
Functional
Description
•A function that
indicates the raw
output value of
the transducer.
•A function that
applies the actual
load to the
transducer and sets
the indicated value
of that time.
●Before conducting
the actual load
calibration, do not
forget to conduct
digital ZERO
function.
Advertisement
Table of Contents
