KYOWA WGA-670B-0 Instruction Manual page 55

Analog Output (D/A Output) .............. Insulated voltage output: ±10 V (Load resistance: 2kΩ or more)
BCD Output ........................................ Output format:
(WGA-670B-1)
RS Output ............................................ Signal method:
(WGA-670B-7)
TEDS Compatible ..............................Interface:
(WGA-670B-7)
Operating Temp & Humid Range ......-10 to 50℃, 20 to 85% RH (Non condensing)
Power Supply ...................................... 100 to 240 VAC ±10%
Dimensions ........................................96(W) × 96(H )× 139(D) (Protruded portion not included)
Weight ................................................. Approximately 1.1kg (WGA-670B-0)
Notation .............................................English or Japanese
EMC Standard ...................................EN61326-1 (Class A)
Safety Standard ..................................EN61010-1 (Installation category: II, Pollution degree: 2)
Insulated current output: 4 to 20 mA (Load resistance: 500 Ω or less)
Output Speed:
Withstand voltage:
Nonlinearity:
Temperature stability:
Output logic:
Output speed:
Driving capacity:
Connector:
Transmission method
Transmission speed
Bit structure:
Connector:
Flow control:
Applicable sensors:
50/60Hz single phase, 20 VA or less
50
Arbitrary scaling is allowed
Fixed to voltage output from 0 to 10 V
500 times/sec
250V AC for 1 minute
Within ±0.１% FS
ZERO Within ±150µV/℃
Sensitivity Within ±0.01%/℃
Insulated open collector output
5 digits, minus code, OVER, printout
command (EOC)
Setting is allowed
15.6, 31.3, 62.5, and 125 times/sec
30 VDC, 20 mA
Equivalent to 57-40360 (DAIICHI DENSHI
KOGYO made)
RS-232C Full duplex method
Asynchronous method
9600 bps
Data bit 7
Stop bit 1
Parity bit Odd number parity
Dsub 9-pin (male)
Not compatible
Compatible with IEEE1451.4 Mixed Mode
Transducer Interface Class 2
Sensor with information conforming to IEEE
template No. 33
Cable length: 30 m or less