Table of Contents
Advertisement
1. PARTS NAMES & PRINCIPAL FUNCTIONS
1-1 FRONT PANEL
A) Indicator ...............................• Indicates measured values, selected functions, and set values.
B) Unit Label
C) [LOCK] LED .......................• When this LED is lit or flickering, no functions are set. Always turn OFF the
D) [HIGH] Limit LED ..............• Lights up when the measured value exceeds the high limit value.
E) [LOW] Limit LED ...............• Lights up when the measured value is less than the low limit value.
F) Operation Key ......................• A pushbutton switch to operate the WGA-670B.
A
D
E
• Normally, it indicates measured values responding to the output from the
transducer. However, if error occurs, the following appears.
OFL1:
When measured value is exceeding the measuring range to the
minus side.
OFL2:
When measured value is exceeding the measuring range to the
plus side.
OFL3:
When the indicated value is below -19999.
OFL4:
When the indicated value is above +19999.
[LOCK] LED before setting functions.
• Flickers when high limit value is indicated.
• Flickers when low limit value is indicated.
For operation, see "4 OPERATION & FUNCTIONS."
4
B
C
F
Advertisement
Table of Contents
