Figure 4: Opening The Container - Mellanox Technologies MSX6506-3R Hardware Installation Manual

InfiniBand FDR Switch Platform Hardware User Manual
3. Unscrew the sides of the crate.
4. Remove and put aside the box.
5. Visually inspect the chassis, make sure that:
• there is no visible damage
• 3 PSUs are installed for theSX6506-3R chassis and
2 PSUs are installed for the SX6506-NR chassis
• all 4 fans are installed
6. Remove all protective plastic film from all sides and top of the chassis.
7. If you wish you may reduce the weight of the chassis by removing all of the power
supply units, and fan units, and put aside for reinstallation after the chassis is installed
in the rack.
1.7.1.5 Installing the Shelf
1. Place the ESD mat on the floor where you will be working and put on the ESD strap.
Make sure the ESD strap is touching your skin and that the other end is connected to
a verified ground.
2. Make sure you have the spine side close to the doors to ensure maximum cable bend-
ing room
Mellanox Technologies

Figure 4: Opening the Container

Container screws
It is highly recommended to have a screw gun or electric screwdriver for this step.
The leafs, spines, and management modules are shipped separately.
22