Energetics POWER RUN 2010HRC Manual page 28

TREADMILL TROUBLE SHOOTING GUIDE
PROBLEM
Treadmill will not start
Treadmill belt slipping
Treadmill noisy
Inaccurate pulse rate
POSSIBLE CAUSES
1. Not plugged in
2. Safety key not attached
correctly
3. Treadmill circuit breaker
tripped
4. On/Off switch not turned on
5. Auto shut down timed out
1. Walking belt too lose
2. Deck needs lubrication
1. Loose hardware
2. Motor straining
3. Clicking sound – roller
knocking
1. Too much hand movement
2. Palms too wet
3. Gripping handgrips too tight
4. Wearing rings
28
CORRECTION
1. Plug into suitable outlet
2. Insert Safety pull pin
3. Reset circuit breaker
4. Tunr on On/Off switch
5. Unplug and re-plug electrical
cord
1. Tighten walking belt
2. Lubricate belt and deck
1. Tighten visible screws, nuts
and bolts.
2. Check belt tension. 3-finger
test.
3. Adjust rear roller -check the
tension
1. Stand on side rails to obtain
accurate pulse reading
2. Dry palms
3. Grip using moderate
pressure
4. Remove all rings