Setting A Message Report - Furuno Felcom 15 Operator's Manual

5. DATA REPORTING AND POLLING
5.1.2

Setting a message report

1. Press the [F5] key to display the Reports menu.
2. Press the [2] key to display the Message Report menu.
3. Press [1], [2], [3] or [4] as appropriate
PIN code is unrelated to data reporting, however it is necessary for polling
(see paragraph 5.2). Enter PIN code as shown below.
4. PIN Code is selected; press the [Enter] key to open the PIN code entry
window.
5. Key in PIN code, using up to eight digits. The PIN code is a password used in
message reports. When a ship receives a polling command w/PIN code from
a shore subscriber and the code matches that of the ship, the ship sends a
message report.
6. Press the [Enter] key to close the window.
7. Press the [ ] key to choose Status.
8. Press the [Enter] key to open the status options window.
5-4
1. Data Report
2. Message Report
3. Data Network ID
Reports menu
Message Report
1. Message Report 1
2. Message Report 2
3. Message Report 3
4. Message Report 4
Message report menu
Message Report
PIN Code
Message Report Programming
Status OFF
Station Name
TELEX
Destination Type
Prefix Code
Country/Ocean Code
Station ID
Modem Type
Address
Subject
LES ID
Regular Interval
Activation
00:10
Interval Time
1 (- - - : No Limit)
Report Times
Start Time1 - - : - -
Start Time2 - - : - -
Start Time3 - - : - -
Start Time4 - - : - -
Report Contents NAV
File
Message report menu
Reports