Furuno Felcom 15 Operator's Manual page 36

2. SYSTEM INITIALIZATION
15. Press the [Enter] key to open the active port options window.
16. Press the [ ] or [ ] key to choose active port (terminal unit); "INT" or "ALL" as
appropriate.
INT:
ALL: Use the terminal unit (PC, etc.) connected to the DTE port on the main
17. Press the [Enter] key to close the window.
18. Press the [ ] key to choose Message Output Port.
19. Press the [Enter] key to open the message output port options window.
20. Press the [ ] or [ ] key to choose the terminal unit where you want to route
received messages.
INT:
EXT:
INT+EXT: All received messages are routed to both the main and external
AUTO:
21. Press the [Enter] key to close the window.
22. Press the [ ] key to choose EGC Output Port.
2-4
Setup
System Date & Time
IMN
MES Operation Mode
Nav Port
Active Port
Message Output Port
EGC Output Port
9. Configuration
Network Setup
Command Window
System setup menu, active port options window
Use main terminal unit.
terminal.
Setup
System Date & Time
IMN
MES Operation Mode
Active Port
Nav Port
Message Output Port
EGC Output Port
9. Configuration
Network Setup
Command Window
System setup menu, message output port options window
All received messages are routed to the main terminal.
All received messages are routed to the terminal unit connected to
the DTE port on the main terminal unit.
terminal units.
The sub address for the DTE port is 001. Received messages
having the sub address of 001 are routed to the DTE terminal.
Messages having a sub address other than 001 are routed to the
main terminal.
System Setup
01:53 02-02-25 (YY-MM-DD)
INMARSAT-C
OFF
INT
DTE1
ALL
DTE1
System Setup
01:53 02-02-25 (YY-MM-DD)
INMARSAT-C
INT
OFF
DTE1
INT
EXT
INT+EXT
AUTO