Table of Contents
Advertisement
Custom Suffix
Enable/Disable Custom Suffix
If custom suffix is enabled, you are allowed to append to the data a user-defined suffix that cannot exceed 10 characters.
For example, if the custom suffix is "AB" and the barcode data is "123", the Host will receive "123AB".
** Disable Custom Suffix
Set Custom Suffix
To set a custom suffix, scan the Set Custom Suffix barcode then the numeric barcodes corresponding to the hexadecimal
value of a desired suffix then the Save barcode.
Note: A custom suffix cannot exceed 10 characters.
Set the custom suffix to "CODE" (HEX: 0x43/0x4F/0x44/0x45):
1.
2.
3.
4.
5.
6.
201
Scan the Enter Setup barcode.
Scan the Set Custom Suffix barcode.
Scan the numeric barcodes "4", "3", "4", "F", "4", "4", "4" and "5" from the "Digit Barcodes" section in
Appendix.
Scan the Save barcode from the "Save/Cancel Barcodes" section in Appendix.
Scan the Enable Custom Suffix barcode.
Scan the Exit Setup barcode.
Set Custom Suffix
Enter Setup
Enable Custom Suffix
** Exit Setup
Advertisement
Table of Contents
